will they switch over

[THE MALIGOON]

these are the motor build 355 SBC two holley 450 carbs ended up there instead of these 2 edlebroke carb's

[mdkingsley]

What happened to it?

[THE MALIGOON]

then I located a 75 76 laguna slope nose and got that all ready for getting installed, and finished the rear quarters in.

[THE MALIGOON]

and the next few pics are 2 weeks before the snowstorm that took out my bro in laws garage where I just took the car to work on it in the heated garage. The roof collapsed from the weight of 11.5" of snow and 3.5" of ice 2 days later poor garage could not take the weight of it, ROOF cave in and then the side of garage fell over on my car, 2 - 6 x6 beams fell across both our cars my 76 laguna and his 80 prostreet camaro(HIS IS ALMOST FIXED BY THE WAY) mine took the brunt of the falling of the roof and beams crushed the roof and trunk area of my car.

So much with this falling in it blew the tires and cracked all 4 of my Ansen slots that were on the car. I had the interior out of the car so all that stuff wasnt damaged door and front clip was the only thing that did survive. Motor was not damaged either so was able to save that.

[W451973]

Originally Posted by THE MALIGOON

these are the control arms I have on my crushed laguna both upper and lowers

Those are nice. Do they have a provision to bolt a stock sway bar up, on the bottem ?

[THE MALIGOON]

Originally Posted by W451973

Those are nice. Do they have a provision to bolt a stock sway bar up, on the bottem ?

yea when you buy them you have to tell them if you want them drilled for the sway bar or not, they provide that at no extra cost BUT you have to specify it when you order them