Misc. Parts For Sale

[brad442]

Guys, I have been going through some of my old parts bins and I am getting rid of old parts that I have multiples of or that I will never use. Therefore I am offering these up on this site as opposed to eBay. Here is what I have for sale, I will post pics of each item separately.

73-75 Heater Hose Bracket - Sand blasted and repainted Underhood Black finish: $20.00

NOS Door Pull Strap Chrome Escutheons - still in package: $25.00

Full set of chrome lug nuts, never used with the exception of one. It was used to hold a wheel in place for a brief time. Perfect condition: $15.00

77 Cutlass Supreme trunk emblem, used, chrome is good, emblem bad. Just can't bring myself to throw it away. $Free, you pay shipping

Hurst Digital Tach Plexiglass replacements. I had these made years ago, cut to correct size, holes are marked where to drill. I only have 3 left: $20.00 each.

Brand new Dome light housing & cover. I was going to use this on my car, but I found an NOS replacement instead. I am including an extra lens as well. $25.00

Carburetor for 76-77 Cutlass/442 with 350. This is a correct numbers carb if you have this year car. This is the Federal Emissions carb, NOT the California or the Hi-Altitude carb. Complete with the exception of the fuel filter housing. I do not know the condition, bought it at a swap meet years ago, but it appears to be in good shape from the outside. I would recommend a rebuild before installing. $50.00

77 Cutlass/442 dash wood bezel. This is the piece that fits on the dash on the passenger side. VERY nice condition and in perfect shape. I retouched up the silver trim around the edges. I would use this on any descent car. $40.00

76/77 Cutlass 442 radiator top bracket. I have a couple of these. This one is in good shape, but will need a good cleaning and paint. I would recommend sand blasting, then powder coating. $10.00

76/77 442 used door sill plates. typical used set. Few dings and scratches, but descent shape. Wood be ok for a driver once cleaned up. You can usually polish these out pretty good. $5.00

Brand new 65" red battery cable. Correct replacement length for a 73-77 Cutlass with a V8. $20.00

Near Perfect Gauge bezels, black in color. These could almost pass as an NOS set. Chrome is darn near perfect with only a couple of minor nicks. Can barely be seen. I would use these for a resto if I needed them. $40.00

And finally... a Brand New DENTED gas tank. Yep, I ordered a brand new gas tank from Tamraz off of eBay. I received the tank, which is a perfect match and fit, yet the one I received was dented. They were supposed to come back and pick the old one up, but never showed up. That was a month ago... So, if anyone is looking to replace their tank, this might be a good deal. I will post the photos to show you the dent, once installed it would not be seen. Shipping on this is expensive, it's about $65.00. I'll sell the tank for $75.00. They are $132.00 new from Tamraz on eBay.

All items require separate cost for shipping. Most items are small, so it wouldn't be too bad.

Close up pics on the way

[brad442]

More photos...

[brad442]

and more...

[brad442]

more...

[brad442]

and yet... more

[brad442]

more photos...

[mdkingsley]

Pm sent on the guage covers and door pulls

[brad442]

gas tank pics...

[76oldswarrior]

Funny thing about the radiator top plate. While changing my 76 rotted radiator core support for a real nice 77s. I went to put on my top plate from the 76 core and the 2 outside holes on the top plate to mount are offset from the 2 inner holes. I had to pick up a 77 top plate. All 4 of the mounting holes are inline on the 77. Just thought I would share that if someones thinking about getting the top plate for their 76.

[brad442]

Funny thing about the radiator top plate. While changing my 76 rotted radiator core support for a real nice 77s. I went to put on my top plate from the 76 core and the 2 outside holes on the top plate to mount are offset from the 2 inner holes. I had to pick up a 77 top plate. All 4 of the mounting holes are inline on the 77. Just thought I would share that if someones thinking about getting the top plate for their 76.

Thanks for letting me know. I would have never guessed that. But after looking at Tex's car, there are quite a few small items that seem to be different from 76 to 77.

[76oldswarrior]

That was only thing different on the support. Just those 4 top plate holes everything else was the same on the support.

[crazy'boutOlds]

Interested in the carb. Can you give me a total shipped to Ohio zip 44515? The lugs, I counted only 16? Are the other four there somewere?

[brad442]

Interested in the carb. Can you give me a total shipped to Ohio zip 44515? The lugs, I counted only 16? Are the other four there somewere?

Let me put the carb in a box and weigh it. I need to find a box it will fit in.

On the lugs, I never noticed there were only 16. I went back and looked and for some weird reason, there are only sixteen! If someone just needs some extras, I will make them a deal on 16!

[bayouh/o]

Interested in one of the digital tach lenses. Shipping to LA 70448? Thanks!

[Ericutlass]

If you are OK to ship to France i'm interested by the set of chrome lug nuts and the red battery cable.
Let me know.

Thanks
Eric

[brad442]

Interested in one of the digital tach lenses. Shipping to LA 70448? Thanks!

Tach lens would be the usual USPS Priority shipping rate - $4.60

[brad442]

Interested in the carb. Can you give me a total shipped to Ohio zip 44515? The lugs, I counted only 16? Are the other four there somewere?

Carb weighs in about 11 pounds, add in a box and packing, you're looking at $22.00 to ship the carb USPS Priority Mail. Let me know if that works for you.

[crazy'boutOlds]

I'll have to pass on that. I think I only paid $29 shipped for the last one I bought from ebay.
Thanks for checking it out, though. Much appreciated.

[brad442]

I'll have to pass on that. I think I only paid $29 shipped for the last one I bought from ebay.
Thanks for checking it out, though. Much appreciated.

No sweat. If you are really interested, just make me an offer. No big deal if not.

[crazy'boutOlds]

HOW ABOUT $50 SHIPPED? Sorry about the cap lock.

[brad442]

HOW ABOUT $50 SHIPPED? Sorry about the cap lock.

Sold! Send payment to:

Brad Bishop
9503 Loma Vista Dr.
Dallas, TX 75243

[crazy'boutOlds]

What , no paypal? If not, I'll try and get to the bank tomorrow during lunch.

[brad442]

What , no paypal? If not, I'll try and get to the bank tomorrow during lunch.

Dude, what am I thinking? We do live in an electronic age nowadays, and I hate having to go to the bank and the Post Office. Yes, you can send me payment via PayPal. My PayPal is my email address:

bb442@sbcglobal.net

[crazy'boutOlds]

Sweet. I'll get it to you tonight. Thanks.

[442/H/O-one]

Are the gauge bezels gone??? I saw someone had refered to gauge covers, I didn't know if they were meaning the gauge bezels or not. If not I will buy them.
Thanks Neil

[brad442]

Are the gauge bezels gone??? I saw someone had refered to gauge covers, I didn't know if they were meaning the gauge bezels or not. If not I will buy them.
Thanks Neil

Neil,

The gauge bezels are spoken for. Mitchell got them, (red & black 76 442). I'll let you know if I run across another set.

[crazy'boutOlds]

Payment sent! Thanks.

[bayouh/o]

Brad, will send ck to you for one of the tach lenses, do not have paypal acct. Thank you.

[77-442]

Brad,
I need the radiator top bracket.

Jim

[texxas8902]

Are the gauge bezels gone??? I saw someone had refered to gauge covers, I didn't know if they were meaning the gauge bezels or not. If not I will buy them.
Thanks Neil

Neil, I have an extra set of the gauge bezels in black. If I remember correctly the chrome trim is nice but not quite as nice as Brad's set. I'm leaving town for about a week but I'll dig them out and take a few pictures when I get back if your interested. Just let me know, I'd take $30 plus shipping since they had a few places that were touched up on the chrome rings down near the gauge face. It has been a few years since I have seen them so I really need to refresh my memory on the exact condition. I do remember when I saw them in the wrecking yard they were nice enough to pull.
David

[brad442]

Brad,
I need the radiator top bracket.

Jim

You got it!

[milesmonte]

Brad:

I would like one of the DIGITAL TACH LENES and the DOOR PULL ESCUTHEONS.

I will send you a MONEY ORDER tommorow.

My zip code is 63376.

Thankyou Brad.:)

[brad442]

Brad:

I would like one of the DIGITAL TACH LENES and the DOOR PULL ESCUTHEONS.

I will send you a MONEY ORDER tommorow.

My zip code is 63376.

Thankyou Brad.:)

Unfortunately the door pull escutheons have been spoken for. I can send you a tach lens.

[Firethorne77]

Brad,
Was surfing some sites tonite on cars for sale and saw this photo for an '87 442 for sale, and looked to me a very familiar 442 sitting next to it (yours?).
Maybe you attended this show and saw this '87 and its condition.?
Little pricy, but it is original and need to remember those are the last 442's .
http://www.americandreamcars.com/1987442081004.htm

[sumrof75]

Brad,
Was surfing some sites tonite on cars for sale and saw this photo for an '87 442 for sale, and looked to me a very familiar 442 sitting next to it (yours?).
Maybe you attended this show and saw this '87 and its condition.?
Little pricy, but it is original and need to remember those are the last 442's .
http://www.americandreamcars.com/1987442081004.htm

Wow, how rare is that color? Don't know if I have ever seen one in teal blue.

[brad442]

Yep, that's me parked beside him. That car was incredible! That show was quite a few years ago, it had less miles back then. Would be a good one to own.

[milesmonte]

Brad: does your Digital Tach Len's have any writing on it or silk screenig like the original's did?

Thank's Miles

[milesmonte]

Brad:
Interested in the GAS TANK what would it run to send to 63376 using FED-X.

Thank's Miles

[brad442]

Guys,

Those of you who were interested in the Hurst Digital Tach Lens, I'm afraid the ones I have won't work. I was out in the garage this evening and the one I was saving, I took the paper tape off of it. Well, as luck would have it, the dark plexi-glass is not translucent. You will not be able to see the numbers from your tachometer if you installed it. If you want one, I will still send it to you, but keep in mind, it won't work...

On a brighter note, I did find ONE extra set of decals I made for the lens of the tach. I only have ONE left... not really planning on making any more. I'll post a pic tomorrow.

[brad442]

Brad:
Interested in the GAS TANK what would it run to send to 63376 using FED-X.

Thank's Miles


FedEx: $81.65
UPS: $210.47

OUCH!!!!

Both of those are ground, non-guaranteed.

If you can find something cheaper, here are the dimensions:
Width: 10"
Height: 40"
Length: 40"

Weight: 42lbs.

[milesmonte]

Brad:
I will take the extra set of Decal's for the Hurst Digital Tach.
Please PM me.

thank's Miles

[Gary-76-442]

Hi Brad this is Gary hang on those door sill plates for me PLEASE Thank you.

[brad442]

Hi Brad this is Gary hang on those door sill plates for me PLEASE Thank you.

Sure will.

[44teetwo]

I might be interested in this panel if you still have it. Drop me a message back or PM me with details. Thanks!
77 Cutlass/442 dash wood bezel. This is the piece that fits on the dash on the passenger side. VERY nice condition and in perfect shape. I retouched up the silver trim around the edges. I would use this on any descent car. $40.00

[crazy'boutOlds]

Wow! Got my carb today! What a great looking piece! Well packaged and all. Can't wait to put it on a motor. What a deal!

[brad442]

Wow! Got my carb today! What a great looking piece! Well packaged and all. Can't wait to put it on a motor. What a deal!

Glad you liked it!

[brad442]

If you have contacted me about a part I have for sale, can you let me know if you still want it. My wife has given me a week to clean out the spare bedroom closet. Gotta get rid of the stuff I don't need. Here is what I have left:

Gas Tank (dented)
'77 Dash pass. side wood grain (perfect condition)
Heater hose bracket - Sand blasted and painted
Door sill Plates - used, but descent condition
Doom light base & lens - brand new
Radiator bracket - used
Cutlass Trunk Emblem - used

Make me an offer...

[Gary-76-442]

Hi Brad this is Gary I want to get those door sill plates.I am going to Lansing show but if you want to send them thats okay to. what ever is easy for you. thank you.

[Ericutlass]

Hi Brad,

Always interested by the lug nuts and the battery cable if you're OK to ship to France.

Thx
Eric

[milesmonte]

Hey Brad:

I will take the GAS TANK.

Send me an E-MAIL with your address and I will send you a MONEY ORDER next Thursday by PRIORITY MAIL when I get paid.

Thank's Miles

[mdkingsley]

Brad, finally got around to opening my gauge bezels and door echelons, great stuff thanks for the great deal. Now they await the restoration.